Assembly and Operation | | | |
1. Check that the permanent filter completely covers the motor opening.Important! |
Never operate the appliance without the filter. |
2. Place the appliance upper section on the dust collector |
3. Fasten the 3 fastening clips by hooking onto the dust collector at bottom and pushing up. |
4. Insert the end of the suction hose in the suction opening. |
5. Connect supplied accessories to vacuum cleaner according to intended application. |
Fasten the required nozzle to the other end of the suction hose. The floor nozzle is very suitable for vacuuming dirt |
on vehicle floor and seats and in the boot. Attach the brush to the floor nozzle to removed driedon dirt and fluff |
(hook on at top, press down and clip into place). The slot nozzle is particularly suitable for areas that |
are not easily accessible such as corners, edges and narrow gaps. |
6. Insert the plug into the cigarette lighter socket of your vehicle or boat. Please make sure that the supply voltage is 12 V . |
7. Switch on the vacuum cleaner with the ON/OFF switch and press the switch in direction ON. Make sure the vacuum |
cleaner's air outlet does not get blocked while using the appliance. |
8. After use, switch the appliance off again using the ON/OFF switch. Then remove the plug from the cigarette lighter socket. |
Never remove the plug by pulling the cable. Store any accessories not being used in a safe place. |
Emptying the Dust Collector | | | |
1. Switch the vacuum cleaner off and remove the plug from the cigarette lighter socket. |
2. Undo the 3 fastening clips by pushing sideways and down. Lift the uppersection of the appliance off the |
dust collector and empty it. |
3. Remove the permanent filter and clean it by brushing and knocking. Place it back in the motor opening |
so that it is seated flush. If the filter is very dirty,it can be washed clean in tepid soap suds. |
Make sure that it has dried completely before putting back into the appliance. |
Re-Assembly | | | |
1. Before reassembling, make sure that the filter is back in position. |
Operating the vacuum cleaner without filter could result in irreparable damage to the appliance. |
2. Put the upper section of the appliance back on the dust collector. |
3. Fasten the 3 fastening clips by hooking onto the dust collector at bottom |
Cleaning the Car Vacuum Cleaner | | | |
Use a dry or slightly moist cloth to clean the appliance. The ventilation slots can easily be cleaned with a brush. |
Do not use chemicals or solvents such as petrol to clean the machine. |
Never immerse the machine in water. |