1. Output Voltage at auto start end 12V

2. Size: 165*79*40MM

3. USB port: 5V, 2.1A

4. Charge mode: CC/CV 15V 1A

5. Start current: 200A

6. Peak current: 400A(3S)

7. Cycle life: 3000 times (Approx 2-3 years)

8. Operating temperature range: -40-85 °C 

9. Operating temperature range: 0-85 °C 

10. Capacity: 13600mAh
 

Functions: 

1. Emergency jump start for 12V auto mobile. 

2. Safe to use in extreme temperature condition. 

3. High luminance and Multi-modes Led lighting. 

4. Support to charge of various brands mobile, MP3/MP4, laptops(no any connector for the MACbook) and tablet. 

5. Multiple safety protection design, to ensure the product have no defect. 
 

Characteristics: 

1. High safety: using rare earth materials, In any case, no fire breaking out and no explosion, accompanying you through the journey with no worries. 

2. Mini exquisite and protable, the battery is 1/5 volume of equivalent specification lead-acid batteries, is daily life necessity of self-driving travel and outdoor sports. 

3. Easy to start, continuously trigger the auto mobile for over 30 times When the power is full. Even the power is less than 20%, it can still start up the engine for emergency. 

4. Powerful LED luminance system: general lighting, SOS distress signal and bright flashing lighting. 

5. Mobile power back up supply: Support to charging various digital product. 

6. Ultra-large battery capacity: charging various digital products up to 2-5 times. 

7. Ultra-long cycle life for over 3000 times. 

8. High temperature resistance safe to store in car and temperature up to 80-85°C degree during day parking. 

9. Low-temperature safety performance of a battery.  

Products Picture: 

Accessories: 

Package: 

Special Note: 

To start 12V car please make sure the product power capacity is 20% or above. Clamp the red jumper cable (i. e. the positive cable) to the dead car's positive battery terminal, which is marked with a "+. " Clamp the black jumper cable (i. e. the negative cable) to the booster car's negative battery terminal, which is marked with a " - ". Make sure that the clamp is firmly connected to the battery and then start the engine. Disconnect the jumper cable one by one after the engine started.